How tall is the most effective angle of the blade / helicopter?
I have a rc helicopter with collective pitch. I want to take maximum battery, where that question. Would a wide angle best? The blade rotating at about 1500 rpm. I think I expressed myself wrong! I wanted to say regardless of headspeed. Which combination of head velocity (rotation of the blade) pitch angle and is the most effective? I think I expressed myself wrong! I wanted to say regardless of headspeed. Which combination of head velocity (rotation of the blade) and pitch angle is the most effective?
The most effective pitch angle of the blade / an RC helicopter to start would be 0 degrees pitch. When at full speed, the blades ground to about 10-12 degrees, or -10 To -12 if you have an acrobatic helicopter. Usually, all RC helicopters not under the same angle. 45 degrees is too much … Youll a spinning not flying the helicopter, if you set it at 45 degrees. Usually, when you have to adjust the height of your helicopter (Disconnect engines first), you should expect and you should view the entire length of each blade to compare the bottom of the blade flat-bottom to the top of the Paddle Control Frame. They should be parallel to each other. If you use blades symmetrical axis of the blade used for comparison. The axis is the midpoint of the lateral plate. (As if you were to slice the blade horizontally in half) This is the median line. ususally you lengthen the Pitch Control Links by half a turn at a time to achieve throttle ratio for good hover. By the way, next time tell us what brand and make the helicopter. Some helicopters can vary, but 98% of the time, it does not. But just to be sure. On my RC helicopter, my setup is as follows: Normal mode: Pitch -2.5 -2.5 0 5 10 0% gas 33% 49% 65% 88% Stunt 1: Pitch -10 -5 0 5 10 Throttle 88% 70% 72.5% 75% 88% 2 stunt: -10 Pitch -5 0 5 10 Throttle 88% 75% 80% 77.5% 88%
Very Funny RC Helicopter Auto Crash, 600 ft Onboard Cam 3D
[affmage source="amazon" results="5"]rc helicopter rpm[/affmage]
[affmage source="overstock" results="5"]rc helicopter rpm[/affmage]
[affmage source="cj" results="5"]rc helicopter rpm[/affmage]
[affmage source="clickbank" results="5"]rc helicopter rpm[/affmage]
[affmage source="linkshare" results=""]rc helicopter rpm[/affmage]
Comments