Help configuring RC servos?
hey im making a weedeater motor boat fiberglass, it will be double-hull design but which I have much experience with the implementation RC servos controlling parts of the boat. Basically, I want something to control speed, you need a servo with enough power to pull a thread of light connected to the throttle servo motors and to control the rudder (s). what is the best way to get this connection doint, do I have an old car and use its RC RC / system should I buy a new one and what I'll look before buying one. Thank you the
The couple of your servo will depend on the size of your boat to steer the rudder. If your boat uses a gasoline engine or nitro then the same applies to the resistance of the accelerator cable and how much rotation servo must do to increase the throttle the engine. The best place to take a look at servos without having to sacrifice a RC car: http://hobbycity.com/hobbyking/store/uh_listCategoriesAndProducts.asp?catname=All+ Servos & idCategory = 84 & ParentCat = 189 Hope this helps
Nitro Setup – Storing your Vehicle 10 of 10
[affmage source="amazon" results="5"]rc car setups[/affmage]
[affmage source="overstock" results="5"]rc car setups[/affmage]
[affmage source="cj" results="5"]rc car setups[/affmage]
[affmage source="clickbank" results="5"]rc car setups[/affmage]
[affmage source="linkshare" results=""]rc car setups[/affmage]
Comments