Servo …………..?
I have two RC servo on my car, they move the throttle and the wheels. I have a simple two-transmitter fixed channel, but when I turn on the servo automatically as they are clockwise. Sometimes they jitter and do not let me move to the first First … Anyway what is wrong and how can I solve this problem? they should not really be in a apostrephe servos …… sorry
If your RC Tx has the standard 2 levers, the left one vertical and one horizontal law, it should also have 2 buttons under the trim levers. You base First work on the left from top to bottom toward the center and then use the trim left to adjust the speed off. It can operate in mode to increase speed. The same applies to the right. Rock-and-forth to both extremes and then go to the center and the use of filling in center of the wheels. This is consistent with the lower end of the plains in the center of the RC rudder and throttle.
May 2010 RC Car Action Table of Contents
[affmage source="amazon" results="5"]rc car channels[/affmage]
[affmage source="overstock" results="5"]rc car channels[/affmage]
[affmage source="cj" results="5"]rc car channels[/affmage]
[affmage source="clickbank" results="5"]rc car channels[/affmage]
[affmage source="linkshare" results=""]rc car channels[/affmage]
Comments