nitro rc car does not respond to the sender?
car was running fine, then suddenly would not respond IVE issuer to verify all connections replaced batteries, even if the former were still OK if you put air transmitter everthing works on the receiver aerial move away a cm and nothing responds any info help would be appreciated Thanks
Check your crystals in the radio (transmitter and receiver) also have a glance that the antenna is intact with no tears or breaks. It appears that you have a large solid matter. Do not turn the engine until it is resolved. Did you cut the receiver antenna at all (it is trying to do so because they are long time)? If so this could be the cause of your problems, something also suggested a problem with the receiver rather than the issuer, but surely, make sure the antenna on the TX is screwed in finger tight and perhaps open the TX and RX (the TX is normally held together by screws 4 or 5 and RX by a clip in the plastic molding and check that nothing has worked is loosely or grilled. Fortunately, 2-channel radio gear is not expensive to replace if necessary.
Wild Hawk RC Plane Aerial Camera footage
[affmage source="amazon" results="5"]rc car aerial[/affmage]
[affmage source="overstock" results="5"]rc car aerial[/affmage]
[affmage source="cj" results="5"]rc car aerial[/affmage]
[affmage source="clickbank" results="5"]rc car aerial[/affmage]
[affmage source="linkshare" results=""]rc car aerial[/affmage]
Comments